Serving Riverdale, Leslieville & the Danforth(437) 494-0899

Electrician Rapid Toronto · Carlaw Ave

Knob-and-tube replacement in Cabbagetown, Riverdale and Leslieville

Some of the oldest houses in Toronto are in our service area. We find the knob-and-tube that is still live in Victorian and Edwardian homes and replace it with grounded circuits, while keeping plaster, trim and the house itself intact.

Why the east end has so much of it

Cabbagetown, Corktown, Riverdale and Leslieville are full of houses built between the 1870s and the 1920s, long before modern wiring. Many were wired with knob-and-tube in the early 1900s, and in a lot of homes some of it is still carrying power today, often hidden behind plaster upstairs while the basement and kitchen were rewired years ago. It has no ground, the insulation becomes brittle with age, and where it has been buried under attic insulation it cannot shed heat the way it was designed to. Many insurers will not cover a house with live knob-and-tube unless there is a plan to replace it.

Balloon framing helps

Many older east-end houses are balloon framed, meaning the wall cavities run continuously from the basement to the attic. That makes it possible to fish new cable up through the walls from below or down from above without opening plaster on every floor, often reaching the second storey in a single pull from the basement. Where blocking, chimneys or past renovations get in the way, we make small, planned openings in spots that are easy to patch. Original trim, mouldings and plaster are treated with care.

How the work is done

We start by tracing what is actually there, from the panel to the outlets and fixtures, and checking the attic and basement for old runs. You get a clear picture of how much knob-and-tube is still live before any pricing is discussed. The rewire is done room by room, with power restored to finished areas each day, so most families can stay in the house. Each old circuit is disconnected at the panel as its replacement goes in. New circuits are grounded, and kitchens, bathrooms and exterior outlets get the protection the current code requires. Rewiring often goes together with a panel upgrade, and the work is done under an ESA permit with a final inspection your insurer can rely on.

How a rewire goes

  1. Inspection. We trace and map the existing wiring and find what is still knob-and-tube.
  2. Scope. A room-by-room plan, with openings marked and any panel work noted.
  3. Rewire in phases. New circuits fished in and old ones disconnected, with the house livable throughout.
  4. ESA inspection. Final inspection and the documentation your insurer will ask for.

Knob-and-tube questions

How do I know if I have knob-and-tube?

Look for single wires on porcelain knobs or through porcelain tubes in the basement or attic. Two-prong outlets are another clue. An inspection confirms how much is live.

Will you have to open my plaster walls?

Very little in most cases. Balloon framing and careful fishing mean most runs go in without opening walls, and the few openings needed are planned for easy repair.

How long does it take?

A few leftover circuits can take a day or two. A full rewire of a Victorian semi usually takes one to two weeks, depending on access and finishes.

Can I replace it in stages?

Yes. The inspection shows which circuits to prioritize, such as anything buried in insulation or feeding kitchens and bathrooms.

Is knob-and-tube always dangerous?

Not automatically, but it is old, ungrounded and often modified or buried in insulation, which is why insurers and inspectors treat it as a priority.

Do you work with renovation contractors?

Yes. If the walls are already open for a renovation, it is the ideal time to rewire, and we coordinate with your contractor’s schedule.