Serving Riverdale, Leslieville & the Danforth(437) 494-0899

Electrician Rapid Toronto · Carlaw Ave

EV charger installation in Riverdale, Leslieville and the Danforth

Home charging for east-end houses with a laneway garage, a parking pad or a driveway. We check your panel first, then run a proper 240 volt circuit to wherever you park.

Parking in the east end

Home charging depends on having somewhere off the street to park. In Leslieville and South Riverdale that is often a garage or pad off the laneway; in Riverdale, Playter Estates and Danforth Village it might be a front pad, a mutual drive or a short driveway. Each one shapes the install:

  • Laneway garage: usually means running a new feed from the house across the yard, overhead or in buried conduit. Many of these garages have no power at all yet, so the same feed can bring lights and an outlet too.
  • Front pad or driveway: an outdoor-rated charger mounted on the house, close enough that the cable reaches the car without crossing a walkway.
  • Garage attached to the house: typically a short, direct run.

Panel capacity comes first

A Level 2 charger needs a dedicated circuit, usually 40 to 60 amps. In a Victorian semi on a 60 or 100 amp service, that is a lot to find. We do a load calculation before recommending anything. If there is room, we add the circuit. If capacity is tight, an EV energy management system can share power with the rest of the house, slowing or pausing charging when other big loads are on, or the charger can be set to a lower current that still covers a typical day’s driving overnight. If neither works, the charger is planned together with a panel or service upgrade.

The charger itself

We install the major home chargers, including Tesla Wall Connector, ChargePoint, Grizzl-E, FLO and Emporia, hardwired for everyday use. Not sure which to buy? Tell us your car and your parking setup and we will suggest one that suits the circuit you can support. If your car came with a portable charger, keep it as a backup, but a wall-mounted Level 2 unit on its own circuit is what makes daily charging quick and dependable. Every install is done under an ESA permit and inspected.

From photos to plugged in

  1. Send photos. Your panel, your parking spot and the path between them, plus the car and charger model.
  2. Load check. We confirm capacity and choose a direct circuit, load management or an upgrade.
  3. Install. Circuit, cable or conduit run, and charger mounted. A laneway garage feed takes longer than a wall near the panel.
  4. Test. The charger’s current is set to match the breaker and tested, with your car if it is home.

EV charger questions

Can you power my laneway garage?

Yes. It usually means a feed from the house across the yard and a small sub-panel in the garage, which can also supply lighting and outlets.

I only have street parking. Can I get a home charger?

Unfortunately not, since chargers and cables cannot cross the sidewalk. If you have any off-street spot, even a small pad, talk to us about it.

Will my 100 amp panel handle a charger?

Often, with load management or a modest charging current. The load calculation will tell us.

How long does an install take?

A charger near the panel is usually a single visit. Garage feeds and panel upgrades add time, and we tell you upfront.

Can two cars share one charger circuit?

Some chargers, such as the Tesla Wall Connector, can share a single circuit between two units and balance the current automatically. It is often the easiest way to charge two EVs on an older east-end service.

Do I need a permit for an EV charger?

Yes. EV charger circuits in Ontario need an ESA permit and inspection, which is part of the job.